New
APM/PIX Galvanometer Voltage And Current Power Meter With 5V 2A BEC Flight Control Power Supply Module View larger

Online only

APM/PIX Galvanometer Voltage And Current Power Meter With 5V 2A BEC Flight Control Power Supply Module

GALVANOMETER-5V-2A-BEC

New product

2 Items

Warning: Last items in stock!

share

By buying this product you can collect up to 85 loyalty points. Your cart will total 85 points that can be converted into a voucher of ₹ 8.50.


₹ 850.00 tax excl.

Add to wishlist

More info

product name: APM.PIX flight control galvanometer 90A 

Product parameters: APM2.6/2.8/PIXHAWK flight control versions are applicable


Used to detect battery voltage and battery current, the flight control board receives these two signals, calculates the remaining battery power, and estimates the remaining flight time.

  





Function: Used to detect battery voltage and battery current. The flight control board receives these two signals, calculates the remaining battery power, and estimates the remaining flight time. In addition, this module also has BEC function, which can output 5.3V DC and maximum 3A continuous current to provide stable power for the flight control board. In addition, the connector of the signal line adopts the Japanese original connector, and the non-domestic connector makes the APM flight control board and the power module reliably connected.

Maximum input voltage is 28V, the maximum current can be measured is 90A, which realizes the monitoring of battery power and voltage by the control board. The design parameters of the voltage and current detection are consistent with the official 3DR design parameters. The setting of the ground plan (mission planer) can refer directly to the official wiki settings .

Please APM flight controllers pay attention to the flight control power supply is best powered from the PM port, because the flight control board circuit has a power supply reverse voltage protection diode and a fuse, this protection circuit only works when the power supply is connected from the PM port. However, the negative effect is that the power supply will generate a voltage drop of 0.3~0.4V after passing through these two components. If a normal 5V power supply module is used, the voltage of VCC on the APM will not reach 5V, if other loads (OSD, digital transmission, receiver, etc.) also directly from the APM flight control board, the voltage of VCC will be lower, there may be no guarantee that the flight control board works normally, but our product is designed to be 5.3V, which can be perfect APM provides power.

30 other products in the same category:

* Local stocks, Lightning 

fast delivery

*

Every time you shop - no minimum order value.

View details