Online only

SIM800 Quad Band GSM/GPRS Serial Modem

SIM800-MODEM

New product

This product is no longer in stock

share

By buying this product you can collect up to 80 loyalty points. Your cart will total 80 points that can be converted into a voucher of ₹ 8.00.


₹ 805.00 tax excl.

Add to wishlist

More info

BEWARE: SIM800 peak power requirments is 3 Amps, as per documentation. Please beware of those cheap LM317 based power supply modules, which can't provide more than 1 Amps. You may experience connectivity issues with those modules. Our product is a high quality module, which uses LM2576 to handle the peak current requirements of SIM800 module and can easily handle up to 3 Amps. Those other manufacturers are selling junk modules, by doing massive cost cutting in various expensive components.

The SIM800 modem has a SIM800 GSM chip and RS232 interface while enables easy connection with the computer or laptop using the USB to Serial connector or to the microcontroller using the RS232 to TTL converter. Once you connect the SIM800 modem using the USB to RS232 connector, you need to find the correct COM port from the Device Manger of the USB to Serial Adapter. Then you can open Putty or any other terminal software and open an connection to that COM port at 9600 baud rate, which is the default baud rate of this modem.
Once a serial connection is open through the computer or your microcontroller you can start sending the AT commands. When you send AT commands for example: 'ATr' you should receive back a reply from the SIM800 modem saying 'OK' or other response depending on the command send.

Important Note:

  • The SIM800 requires huge power, so use a 12V DC 2 to 3 Amps adapter, any wrong adapter might cause damage also to the modem.
  • On the board there are Tx(D) and Rx(D) pins, near the 5V and GND pins, don't ever connect anything to them or send any command to them, they are not the TTL pins for serial communication, they are for upgrading the firmware, and if you connect them to the microcontroller or computer, the firmware will get damaged and the module will stop working.
  • Please read carefully the marking on the SIM card tray on how to open or close, those are made of brittle plastics and will break if you put too much pressure on them, so be very gentle and careful while removing or inserting SIM Cards.
  • Don't tight the antenna too much, the screw threads might get damaged by excessive or over tightening of antenna.
  • Please don't touch the connections or components and always put the modem on a non conductive base.

18 other products in the same category:

* Local stocks, Lightning 

fast delivery

*

Every time you shop - no minimum order value.

View details